- The steps for the implementation of the tattoo are as follows:
- Choice of design, its size and its location on the body.
- Implementation of the stencils on tracing paper to transfer the desired pattern on the skin through the use of pencil ectografica (indelible pencil) or pen drawing technique normally not exceeding 0.3. Some tattoo artists use stencils for the deodorant stick that is very effective, but for reasons of hygiene and practicality should obtain appropriate products (stencil Tat) sold by many companies to professional tattoo supplyes.
- E 'shaved if necessary and advisable to disinfect the part before applying the stencil tat, and when you print the cast wait a few minutes to allow time for it to dry well and onto the skin. The practitioner must also be sure to print the drawing in the best position to avoid nasty surprises that may occur in the finished work. The wrong location could be wrong with the tattoo when changing position of the person and why you need the right eye and experience.
- From here comes the advice and more to rely on the work of professionals who have the right knowledge and experience in the field.
- After that you pass to the realization that, depending on the type of design will start with:
- The application of vaseline better if soothing, antirritante and added vitamins.
Apply with disposable wooden spatula and pull out now especially needed Vaseline to work, so as to avoid having riattingere additional product from the jar with your hands or a spatula coming into contact with blood and color.
- For typing dell'outline (boundary line) it is necessary to use a properly calibrated machine to flatten the dry tip and special needlebar liner (stick needles converging boundary. RLB), which can typically vary from a minimum needles of three to over 10 depending on the design you want, and usually at a current of not more than 8 / 9 V.
- the beating should be at the right speed in drawing the lines and keep the right level of depth of penetration otherwise the skin color, skin healed, or will tend to leave if they fail to hand pressure or migrate (spread unevenly under the skin immediately or over time) as well as serum and blood to release more than necessary may lead to the formation of crust with consequent loss of gloss of the tattoo.
- using a spray bottle filled with water and green soap to clean the excess color at work. The green soap green soap is a special detergent and antibacterial antirritante. Use it carefully during construction of the tattoo being careful not to remove the cast on the skin.
For the nuances you have to calibrate the machine with the beat or use a special softer and substantially lower the voltage on the feeder. We use ferrules and needlebars with needles or flat shader (needles are Flat Rack F, Shader are arranged in a circular RSB) of various quantities of needles as needed.
- For color fills the backgrounds that need it is always recommended by the machine, or set with a soft beat, but the voltage must be typically used for the outline. In addition, you must use special tips and needlebars Magnum needles (needles placed in double rack M).
- Once you have completed the cleaning work well with the green soap dry and sprinkle with the tattoo Vaseline. Cover the tattoo with plastic wrap.
0 comments:
Post a Comment